Zagospodarowanie odpadów sztywnych pianek poliuratenowo-poliizocyjanuranowych w wyniku ich alkoholizy połączonej z aminolizą

B. Czupryński; J. Paciorek-Sadowska; J. Liszkowska; J. Czupryńska

Published : 2022-09-18

Vol. 47 No. 2 (2002)

The utilization of rigid polyurethane-polyisocyanurate foams by the combined alcoholysis-aminolysis process

B. Czupryński J. Paciorek-Sadowska J. Liszkowska J. Czupryńska

Abstract

Rigid PUR-PIR foams prepared (i) with addition or (ii) with no addition of a solid fraction of rye slops or potato slops were both alcoholyzed and aminolyzed. The alcoholyzate was used to replace the original polyether polyol, 0.05-0.20 of chemical equivalent, which is used to prepare foams (Table 2). Three series of foams were prepared, varying in the amount of the alcoholyzate added. Apparent density, compression strength, brittleness, oxygen index, combustion residue, stability of linear dimensions, volume change (in 48 h at 120degreesC), and softening point (Table 3, Figs. 2-4) were determined. As the proportion of the alcoholyzate was raised from 0.05 to 0.2 chemical equivalent, the compression strength of the mode (ii) foams (foams 1.1-1.4) rose, whereas brittleness, oxygen index and softening point remained practically unaffected as compared with control foam (foam 1.0 with no alcoholyzate added). In the mode (i) foams (solid fraction of rye slops added) prepared with the alcoholyzate added (foams 2.1-2.4), the compression strength rose but slightly (from 208.7 kPa in control foam to 229.0 kPa in foam containing 0.2 chem. equiv. of alcoholyzate) and the brittleness and softening point fell. The foams containing the alcoholyzate and the solid fraction of potato slops (foams 3.1-3.4) exhibited not only lower brittleness and reduced softening points but also lower compression strengths. In each foam examined, the oxygen index and combustion residue remained practically unaffected as compared with controls. IR spectra confirmed the presence of the urethane and isocyanurate groups in the foams prepared.

Keywords

sztywne pianki poliuretanowo-poliizocyjanuranowe ; recykling ; alkoholiza z aminolizą ; utylizacja wywaru żytniego i ziemniaczanego ; fizyczne właściwości pianek ; mechaniczne właściwości pianek rigid polyurethane-polyisocyanurate foams ; recycling ; alcoholysis and aminolysis ; utilization of rye slops and potato

Similar Articles

A. Żmihorska-Gotfryd, Effect of resol phenol-formaldehyde resin modification with the products of poly(ethylene terephthalate) chemical degradation on the properties of the resin , Polimery: Vol. 49 No. 6 (2004)
W. Mazela, P. Czub, J. Pielichowski, Applications of epoxy resins in electronics and optoelectronics. Part III, Epoxy resins with nonlinear optical properties , Polimery: Vol. 52 No. 7-8 (2007)
A. Figiel, T. Zięba, W. Leszczyński, The effect of moisture content and composition on tensile properties of the synthetic polymer/starch composition , Polimery: Vol. 49 No. 7-8 (2004)
M. Kwacz, S. Chizhik, Z. Rymuza, Z. Kusznierewicz, Investigation of mechanical properties of surface layer of polymeric elements of miniature slide bearing using atomic force microscope , Polimery: Vol. 49 No. 7-8 (2004)
M. Żenkiewicz, Investigation of tensile properties and tear resistance of polypropylene film modified by irradiation , Polimery: Vol. 48 No. 1 (2003)
A. Krzyżak, J. W. Sikora, Processability of phenolic plastics determined by BIP method , Polimery: Vol. 52 No. 1 (2007)
S. Kucharski, E. Ortyl, Refractive index modulation in films containing single and dual chromophore system , Polimery: Vol. 51 No. 7-8 (2006)
E. Hałasa, Polyimides. Part II. Processing, functional properties and application , Polimery: Vol. 48 No. 4 (2003)
C. Cossard, S. Kuciel, S. Mazurkiewicz, A. Liber-Kneć, Possibility of using polyamide 6 reinforced with glass fiber for Ilizarov rings , Polimery: Vol. 53 No. 4 (2008)
E. Hałasa, Synthesis of polyimides from poly(amic acids) and their esters , Polimery: Vol. 50 No. 1 (2005)

<< < 71 72 73 74 75 76 77 78 79 80 > >>

You may also start an advanced similarity search for this article.

Details

Statistics

Authors

Download files

PDF (Język Polski)

Zasady cytowania

Czupryński, B., Paciorek-Sadowska, J., Liszkowska, J., & Czupryńska, J. (2022). The utilization of rigid polyurethane-polyisocyanurate foams by the combined alcoholysis-aminolysis process. Polimery, 47(2), 104–109. Retrieved from https://polimery.ichp.vot.pl/index.php/p/article/view/1950

Citing articles via

Statistics

Total abstract views : 0

PDF Downloads : 0

B. Czupryński polimery@ichp.pl

Affiliation
Akademia Bydgoska Kazimierza Wielkiego, Instytut Techniki, Chodkiewicza 30, 85065 Bydgoszcz, Poland

J. Paciorek-Sadowska

J. Liszkowska

J. Czupryńska