Zagospodarowanie odpadów sztywnych pianek poliuratenowo-poliizocyjanuranowych w wyniku ich alkoholizy połączonej z aminolizą

B. Czupryński; J. Paciorek-Sadowska; J. Liszkowska; J. Czupryńska

Published : 2022-09-18

Vol. 47 No. 2 (2002)

The utilization of rigid polyurethane-polyisocyanurate foams by the combined alcoholysis-aminolysis process

B. Czupryński J. Paciorek-Sadowska J. Liszkowska J. Czupryńska

Abstract

Rigid PUR-PIR foams prepared (i) with addition or (ii) with no addition of a solid fraction of rye slops or potato slops were both alcoholyzed and aminolyzed. The alcoholyzate was used to replace the original polyether polyol, 0.05-0.20 of chemical equivalent, which is used to prepare foams (Table 2). Three series of foams were prepared, varying in the amount of the alcoholyzate added. Apparent density, compression strength, brittleness, oxygen index, combustion residue, stability of linear dimensions, volume change (in 48 h at 120degreesC), and softening point (Table 3, Figs. 2-4) were determined. As the proportion of the alcoholyzate was raised from 0.05 to 0.2 chemical equivalent, the compression strength of the mode (ii) foams (foams 1.1-1.4) rose, whereas brittleness, oxygen index and softening point remained practically unaffected as compared with control foam (foam 1.0 with no alcoholyzate added). In the mode (i) foams (solid fraction of rye slops added) prepared with the alcoholyzate added (foams 2.1-2.4), the compression strength rose but slightly (from 208.7 kPa in control foam to 229.0 kPa in foam containing 0.2 chem. equiv. of alcoholyzate) and the brittleness and softening point fell. The foams containing the alcoholyzate and the solid fraction of potato slops (foams 3.1-3.4) exhibited not only lower brittleness and reduced softening points but also lower compression strengths. In each foam examined, the oxygen index and combustion residue remained practically unaffected as compared with controls. IR spectra confirmed the presence of the urethane and isocyanurate groups in the foams prepared.

Keywords

sztywne pianki poliuretanowo-poliizocyjanuranowe ; recykling ; alkoholiza z aminolizą ; utylizacja wywaru żytniego i ziemniaczanego ; fizyczne właściwości pianek ; mechaniczne właściwości pianek rigid polyurethane-polyisocyanurate foams ; recycling ; alcoholysis and aminolysis ; utilization of rye slops and potato

Similar Articles

P. Siwek, A. Libik, K. Twardowska-Shmidt, D. Ciechańska, I. Gryza, Biopolymers and their applications in agriculture , Polimery: Vol. 55 No. 11-12 (2010)
M. Oleksy, M. Heneczkowski, G. Budzik, Composites of unsaturated polyester resins applied in vacuum casting technology , Polimery: Vol. 53 No. 2 (2008)
J. Walendziewski, Hydrocarbon fractions from the thermal cracking of polyolefin wastes - synthesis, purification and applications , Polimery: Vol. 55 No. 10 (2010)
A. Bryll, K. Michalska-Małecka, S. Grzegorczyn, A. Ślęzak, Model equation of relative solute permeability coefficient of membrane-concentration boundary layers complex , Polimery: Vol. 54 No. 9 (2009)
M. Żenkiewicz, P. Rytlewski, A. Tracz, W. Mróz, J. Richert, Effects of laser radiation on some properties of the surface layer of polycarbonate , Polimery: Vol. 54 No. 9 (2009)
M. Zdanowicz, T. Spychaj, Ionic liquids as starch plasticizers or solvents , Polimery: Vol. 56 No. 11-12 (2011)
M. Kozłowski, A. Kozłowska, S. Frąckowiak, Cell-structured polymeric materials , Polimery: Vol. 55 No. 10 (2010)
M. Żenkiewicz, Corona discharge in an air as a method of modification of polymeric materials' surface layers , Polimery: Vol. 53 No. 1 (2008)
S. Kudła, Crosslinking of binary blends of ethylene/vinyl acetate copolymer and low density polyethylene or metallocene polyolefin elastomer as heat-shrinkable materials , Polimery: Vol. 54 No. 1 (2009)
A. Kosmalska, M. Zaborski, J. Sokołowska, The properties of SiO2/dye composite pigments and their applications for silicone rubber , Polimery: Vol. 55 No. 3 (2010)

<< < 92 93 94 95 96 97 98 99 100 101 > >>

You may also start an advanced similarity search for this article.

Details

Statistics

Authors

Download files

PDF (Język Polski)

Zasady cytowania

Czupryński, B., Paciorek-Sadowska, J., Liszkowska, J., & Czupryńska, J. (2022). The utilization of rigid polyurethane-polyisocyanurate foams by the combined alcoholysis-aminolysis process. Polimery, 47(2), 104–109. Retrieved from https://polimery.ichp.vot.pl/index.php/p/article/view/1950

Citing articles via

Statistics

Total abstract views : 0

PDF Downloads : 0

B. Czupryński polimery@ichp.pl

Affiliation
Akademia Bydgoska Kazimierza Wielkiego, Instytut Techniki, Chodkiewicza 30, 85065 Bydgoszcz, Poland

J. Paciorek-Sadowska

J. Liszkowska

J. Czupryńska