Wpływ struktury na właściwości piezoelektryczne elektretów polipropylen-montmorylonit

Bogusław Królikowski; Halina Kaczmarek; Ewa Klimiec; Marta Chylińska; Dagmara Bajer

doi:10.14314/polimery.2019.7.4

Published : 2021-01-12

Vol. 64 No. 7-8 (2019)

Influence of structure on piezoelectric properties of polypropylene-montmorillonite electrets

Bogusław Królikowski Halina Kaczmarek Ewa Klimiec Marta Chylińska Dagmara Bajer

DOI: https://doi.org/10.14314/polimery.2019.7.4

Abstract

The effect of the structure, mechanical properties and filler content of isotactic polypropylene (i-PP)/modified montmorillonite (MMT) composite films on their piezoelectric properties was investigated. The introduction of MMT mineral filler into the i-PP allowed to produce the films with cellular structure, confirmed by scanning electron microscopy (SEM), using extrusion method. The uniaxial orientation of the film increased its degree of crystallinity. After polarization in an electric field of intensity ca. 100 V/μm the films showed piezoelectric properties. The stability of obtained electrets was evaluated based on piezoelectric voltage measured during the storage of films at room temperature. The cellular structure and increase in crystallinity degree of the films influenced the increase in piezoelectric charge coefficient d33 compared to neat i-PP. The d33 values obtained under higher and lower stresses of tested specimens are almost twice higher than those determined for solid (compact) poly(vinylidene fluoride) (PVDF) film and non-oriented i-PP film. This opens up the possibility of application of the obtained composite films for pressure sensors with wide applicability due to the relatively not complicated manufacturing method.

Keywords

kompozyty polimerowe ; polipropylen izotaktyczny ; modyfikowany montmorylonit ; napięcie piezoelektryczne ; gęstość ładunku ; stała piezoelektryczna ładunkowa polymer composites ; isotactic polypropylene ; modified montmorillonite ; piezoelectric voltage ; charge density ; piezoelectric charge constant

Similar Articles

M. Sajid Ali Asghar, Muhammad Amir, Umer Hussain, Mohammed M. Sabri, Zinc and graphene oxide composites as new protective coatings for oil and gas pipes , Polimery: Vol. 68 No. 7-8 (2023)
Małgorzata Oleksy, Klaudia Dynarowicz, David Aebisher, Polymer and composite materials used in medicine - an overview , Polimery: Vol. 68 No. 7-8 (2023)
Ameen Hadi Mohammed, Ameera Hassan Hamed, Areej Kamal Assim Aldabbagh, Synthesis and characterization of modified PVC waste with different diamines for Hg(II) removal , Polimery: Vol. 68 No. 11-12 (2023)
Sandra Paszkiewicz, Grzegorz Kramek, Konrad Walkowiak, Izabela Irska, Elżbieta Piesowicz, Monika Rzonsowska, Beata Dudziec, Mateusz Barczewski, Thermal and mechanical properties of PLA/ENR thermoplastic vulcanizates compatibilized with tetrafunctional double-decker silsesquioxanes , Polimery: Vol. 68 No. 11-12 (2023)
J. Stasiek, The effects of constructional solutions of plasticizing screw configurations and extrusion conditions on polypropylene composite properties , Polimery: Vol. 50 No. 11-12 (2005)
M. Kacperski, Polymer nanocomposites. Part I. General characteristics, fillers and nanocomposites based on termosetting polymers , Polimery: Vol. 47 No. 11-12 (2002)
A. Plichta, Z. Florjańczyk, G. Rokicki, Cyclic carbonates in the synthesis of biodegradable polymers , Polimery: Vol. 50 No. 7-8 (2005)
S. Rabiej, On the origin of the multiple melting observed after isothermal crystallization of homogeneous ethylene/1-octene copolymers , Polimery: Vol. 49 No. 6 (2004)
J. Janik, S. Lenart, W. Królikowski, P. Penczek, Polymer blends PET/PE-LD and PET/PP with a new compatibilizer , Polimery: Vol. 49 No. 6 (2004)
W. Fabianowski, B. Polak, M. Lewandowska-Szumieł, Polymers for bone reconstruction - evaluation of chosen polimeric substrates in osteoblasts in vitro culture , Polimery: Vol. 49 No. 7-8 (2004)

<< < 20 21 22 23 24 25 26 27 28 29 > >>

You may also start an advanced similarity search for this article.

Details

Statistics

Authors

Download files

PDF (Język Polski)

Zasady cytowania

Królikowski, B., Kaczmarek, H., Klimiec, E., Chylińska, M., & Bajer, D. (2021). Influence of structure on piezoelectric properties of polypropylene-montmorillonite electrets. Polimery, 64(7-8), 493–498. https://doi.org/10.14314/polimery.2019.7.4

Altmetric indicators

Citing articles via

Statistics

Total abstract views : 0

PDF Downloads : 0

Bogusław Królikowski b.krolikowski@impib.pl

Affiliation
Instytut Inżynierii Materiałów Polimerowych i Barwników, ul. M. Skłodowskiej-Curie 55, 87-100 Toruń

Halina Kaczmarek

Affiliation
Uniwersytet Mikołaja Kopernika w Toruniu, Wydział Chemii, ul. Gagarina 7, 87-100 Toruń

Ewa Klimiec

Affiliation
Instytut Technologii Elektronowej, Oddział w Krakowie, ul. Zabłocie 39, 30-701 Kraków

Marta Chylińska

Affiliation
Uniwersytet Mikołaja Kopernika w Toruniu, Wydział Chemii, ul. Gagarina 7, 87-100 Toruń

Dagmara Bajer

Affiliation
Uniwersytet Mikołaja Kopernika w Toruniu, Wydział Chemii, ul. Gagarina 7, 87-100 Toruń