Zagospodarowanie odpadów sztywnych pianek poliuratenowo-poliizocyjanuranowych w wyniku ich alkoholizy połączonej z aminolizą

B. Czupryński; J. Paciorek-Sadowska; J. Liszkowska; J. Czupryńska

Published : 2022-09-18

Vol. 47 No. 2 (2002)

The utilization of rigid polyurethane-polyisocyanurate foams by the combined alcoholysis-aminolysis process

B. Czupryński J. Paciorek-Sadowska J. Liszkowska J. Czupryńska

Abstract

Rigid PUR-PIR foams prepared (i) with addition or (ii) with no addition of a solid fraction of rye slops or potato slops were both alcoholyzed and aminolyzed. The alcoholyzate was used to replace the original polyether polyol, 0.05-0.20 of chemical equivalent, which is used to prepare foams (Table 2). Three series of foams were prepared, varying in the amount of the alcoholyzate added. Apparent density, compression strength, brittleness, oxygen index, combustion residue, stability of linear dimensions, volume change (in 48 h at 120degreesC), and softening point (Table 3, Figs. 2-4) were determined. As the proportion of the alcoholyzate was raised from 0.05 to 0.2 chemical equivalent, the compression strength of the mode (ii) foams (foams 1.1-1.4) rose, whereas brittleness, oxygen index and softening point remained practically unaffected as compared with control foam (foam 1.0 with no alcoholyzate added). In the mode (i) foams (solid fraction of rye slops added) prepared with the alcoholyzate added (foams 2.1-2.4), the compression strength rose but slightly (from 208.7 kPa in control foam to 229.0 kPa in foam containing 0.2 chem. equiv. of alcoholyzate) and the brittleness and softening point fell. The foams containing the alcoholyzate and the solid fraction of potato slops (foams 3.1-3.4) exhibited not only lower brittleness and reduced softening points but also lower compression strengths. In each foam examined, the oxygen index and combustion residue remained practically unaffected as compared with controls. IR spectra confirmed the presence of the urethane and isocyanurate groups in the foams prepared.

Keywords

sztywne pianki poliuretanowo-poliizocyjanuranowe ; recykling ; alkoholiza z aminolizą ; utylizacja wywaru żytniego i ziemniaczanego ; fizyczne właściwości pianek ; mechaniczne właściwości pianek rigid polyurethane-polyisocyanurate foams ; recycling ; alcoholysis and aminolysis ; utilization of rye slops and potato

Similar Articles

U. Szeluga, L. Kurzeja, H. Galina, Modification of epoxy-novolak compositions with reactive rubbers and coal as a filler , Polimery: Vol. 51 No. 11-12 (2006)
A. Liber-Kneć, S. Kuciel, W. Dziadur, Estimation of mechanical (static and dynamic) properties of recycled polypropylene filled with wood flour , Polimery: Vol. 51 No. 7-8 (2006)
B. Świerz-Motysia, R. Jeziórska, A. Szadkowska, M. Piotrowska, Synthesis and properties of biodegradable polylactide and thermoplastic starch blends , Polimery: Vol. 56 No. 4 (2011)
B. Czupruński, J. Paciorek-Sadowska, J. Liszkowska, The effect of tri(1-chloro-3-etoxy-propane-2-ol) borate on the properties of rigid polyurethane-polyisocyanurate foams , Polimery: Vol. 47 No. 10 (2002)
R. Jeziórska, A. Szadkowska, B. Świerz-Motysia, J. Kozakiewicz, Effect of "core-shell” polymeric nanofiller on the structure and properties of polylactide and thermoplastic corn starch blend , Polimery: Vol. 57 No. 5 (2012)
A. Boczkowska, K. Babski, J. Osiński, P. Żach, Modeling of characteristics at compression and functinal properties of hyperelastic polyurethane materials applied in mechanical engineering , Polimery: Vol. 53 No. 7-8 (2008)
A. Nassar, A. A. Yehia, S. H. El-Sabbagh, Evaluation of the physico-mechanical and electrical properties of styrene-butadiene rubber/aluminum powder and styrene-butadiene rubber/cerium sulfate composites , Polimery: Vol. 60 No. 2 (2015)
M. Sołtysiński, K. Piszczek, D. Romecki, S. Narożniak, J. Tomaszewska, K. Skórczewska, Conversion of polyurethane technological foam waste and post-consumer polyurethane mattresses into polyols – industrial applications , Polimery: Vol. 63 No. 3 (2018)
M. Masłowski, M. Zaborski, Effect of thermooxidative and photooxidative ageing processes on mechanical properties of magnetorheological elastomer composites , Polimery: Vol. 60 No. 4 (2015)
M. Bączek, J. Janicki, Supermolecular structure and selected properties of PA 6/LCO modified fibres , Polimery: Vol. 56 No. 9 (2011)

<< < 5 6 7 8 9 10 11 12 13 14 > >>

You may also start an advanced similarity search for this article.

Details

Statistics

Authors

Download files

PDF (Język Polski)

Zasady cytowania

Czupryński, B., Paciorek-Sadowska, J., Liszkowska, J., & Czupryńska, J. (2022). The utilization of rigid polyurethane-polyisocyanurate foams by the combined alcoholysis-aminolysis process. Polimery, 47(2), 104–109. Retrieved from https://polimery.ichp.vot.pl/index.php/p/article/view/1950

Citing articles via

Statistics

Total abstract views : 0

PDF Downloads : 0

B. Czupryński polimery@ichp.pl

Affiliation
Akademia Bydgoska Kazimierza Wielkiego, Instytut Techniki, Chodkiewicza 30, 85065 Bydgoszcz, Poland

J. Paciorek-Sadowska

J. Liszkowska

J. Czupryńska