Język Polski
English
Published
: 2022-09-18
Problems of engineering design and production of screws in counter-rotating twin-screw extruders
Abstract
Sequence of basic steps required during conceptual design of twin-screw plasticizing systems has been presented (Fig. 2). Bibliographic data allowed analysis of intermeshing flows to be performed and their effect on the plasticizing process was determined. Results of investigating the axial and frontal screw outline were presented, confirming changeability of the screw outline course in different cross-sections along screw axis. Change in the angle of flight flank inclination along the screw zone (beta) requires appropriate change in the channel width, b, along this zone to maintain the existing intermeshing gap (Fig. 3.). Also, in zones where the screw helix angles (phi(st)) exceed 35degrees and difference of helix angles (phi(w) - phi(z)) > 15degrees, suitable enhancing of side inter-screw gap or scarfing of the flight edges are required to attain its appropriate minimum value (> 0.5 mm). Gap between the interacting screws varies at different locations of the flank surface of the flights - e.g. is higher in axial cross- section as compared with the plane perpendicular to flight inclination on the pitch diameter of screws (Fig. 11). Shape of the side intermeshing gap should be approximately rhomboidal Fig. 3), i.e. the difference of the side inter-screw gap (S-b max). - S-b (min.)) should be from 0.1 to 0.3 mm, to maintain ass flowing through the gap along is width, h(e), under pproximately identical shearing rate.
Details
Statistics
Authors
Zasady cytowania
Stasiek, J., & Nieszporek, T. (2022). Problems of engineering design and production of screws in counter-rotating twin-screw extruders. Polimery, 47(6), 441–449. Retrieved from https://polimery.ichp.vot.pl/index.php/p/article/view/1988
