Niekonwencjonalne sieciowanie mieszanin chlorosulfonowanego polietylenu i karboksylowanego kauczuku butadienowo-akrylonitrylowego

M. Kozioł; W. M. Rzymski

Published : 2022-09-01

Vol. 50 No. 7-8 (2005)

Unconventional crosslinking of the blends of chlorosulfonated polyethylene and carboxylated acrylonitrile-butadiene rubber

M. Kozioł W. M. Rzymski

Abstract

Interpolymeric crosslinking of chlorosulfonated polyethylene/carboxylated acrylonitrile-butadiene rubber blends (CSM/XNBR) (Table 2) with MgO in the presence of stearic acid at temp. 433 K (160 oC) for 30 min has been investigated. Effect of CSM containing various amounts of chlorine bonded (Table 1) on the properties of CSM/XNBR blends was studied as well. Extent of crosslinking was estimated on the basis of determinations of vulcametric torque (L) (Fig. 1), equilibrium swelling (Qv) in selected solvents and sol fraction content (fraction soluble in 2-butanone - S) (Tables 3 and 5). It was found that CSM did not undergo crosslinking in given conditions while in the blend with XNBR the interpolymeric reaction of both elastomers occurred. It was confirmed by bounded chlorine values, S and IR analysis (Fig. 2, Table 4). It was observed that degree of CSM bonding with the network depends on its type and content in the blend. Tensile strength (TSb), elongation at break (Eb) temperature dependence of dynamic loss tangent (tgd) and storage modulus (E') (Fig. 3) were determined using dynamic mechano-thermal analysis (DMTA) of cured CSM/XNBR blends. There were found ionic interpolymeric bonds of structure ~C-CO-O-+Mg+-O-SO2-C~ in cured CSM/XNBR blend [equations (1)-(3)] which gave the blend high mechanical strength and act as chemical compatibilizer.

Keywords

polietylen chlorosulfonowany ; karboksylowany kauczuk butadienowo-akrylonitrylowy ; mieszaniny elastomerów ; sieciowanie ; wiązania interpolimerowe ; właściwości mechaniczne chlorosulfonated polyethylene ; carboxylated acrylonitrile-butadiene rubber ; blends of elastomers ; crosslinking ; interpolymeric bonds ; mechanical properties

Similar Articles

P. Rybiński, G. Janowska, S. Kuberski, Thermal properties of butadiene-acrylonitrile rubbers , Polimery: Vol. 48 No. 3 (2003)
C. N. Cascaval, A. Mititelu-Mija, Curing reaction of azomethine epoxy liquid crystals , Polimery: Vol. 52 No. 4 (2007)
Bronisław Samujło, The effect of natural fillers on the mechanical properties and flammability of low-density polyethylene , Polimery: Vol. 68 No. 7-8 (2023)
A. K. Błędzki, O. Faruk, H. Kirschling, J. Kühn, A. Jaszkiewicz, Microcellular polymer and composites. Part II. Properties of different types of microcellular materials , Polimery: Vol. 52 No. 1 (2007)
Natalia Kowalska, Paweł Szczygieł, Michał Skrzyniarz, Sławomir Błasiak, Effect of shells number and machining on selected properties of 3D-printed PLA samples , Polimery: Vol. 69 No. 3 (2024)
Karina Rusin-Żurek, Stanisław Kuciel, Maria Kurańska, The effect of funcionalized ethylene-n-octene copolymer on mechanical properties of bioPET with organic waste fillers , Polimery: Vol. 68 No. 6 (2023)
R. Jeziórska, Effect of poly(butylene terephthalate) functionalized with 2,2'-(1,3-phenylene)-bis(2-oxazoline) on the structure and properties of polyamide 6 blends with textile waste containing poly(ethylene terephthalate) , Polimery: Vol. 53 No. 3 (2008)
Dorota Skowrońska, Katarzyna Wilpiszewska, Potato starch plasticization by natural deep eutectic solvent , Polimery: Vol. 68 No. 9 (2023)
P. Zdebiak, P. El Fray, Influence of soft segments on thermal and mechanical properties of terpoly(ester-ether-ester)s , Polimery: Vol. 53 No. 10 (2008)
Małgorzata Szymiczek, Sara Sarraj, Monika Chomiak, Błażej Chmielnicki, Izabela Gajlewicz, Structure and properties of self-extinguishing rigid polyurethane foam with inorganic filler , Polimery: Vol. 69 No. 4 (2024)

<< < 23 24 25 26 27 28 29 30 31 32 > >>

You may also start an advanced similarity search for this article.

Details

References

Statistics

Authors

Download files

PDF (Język Polski)

Zasady cytowania

Kozioł, M., & Rzymski, W. M. (2022). Unconventional crosslinking of the blends of chlorosulfonated polyethylene and carboxylated acrylonitrile-butadiene rubber. Polimery, 50(7-8), 587–592. Retrieved from https://polimery.ichp.vot.pl/index.php/p/article/view/1667

Citing articles via

Statistics

Total abstract views : 0

PDF Downloads : 0

M. Kozioł

Affiliation
Politechnika Łódzka, Instytut Polimerów, ul. Stefanowskiego 12/16, 90-924 Łódź

W. M. Rzymski rzymski@p.lodz.pl

Affiliation
Politechnika Łódzka, Instytut Polimerów, ul. Stefanowskiego 12/16, 90-924 Łódź